XC18V04VQG44C DataSheet
DATASHEET
XC18V04VQG44C 描述
Leakage Current: Capacitors shall be stabilized at the rated temperature for 30 minutes. Rated voltage shall be applied to capacitors for 5 minutes using a steady source of power (such as a regulated power supply) with 1000 ohm resistor connected in series with the capacitor under test to limit the charging current. Leakage current shall then be measured.
XC18V04VQG44C 特点
w High speed 800,711 and 600 MHz RDRAM storage w 184 edge connector pads with 1 mm pad spacing w Maximum module PCB size: 133.5mm x 31.75mm x 1.37mm(5.21 x 1.25 x 0.05) w Each RDRAM has 32 banks, for a total of 512, 384, 256, 192 or 128 banks on each 256MB, 192MB, 128MB, 96MB, or 64MB module respectively w Gold plated edge connector pad contacts wSerial Presence Detect(SPD) support ¾w Operates from a 2.5 volt supply (¡ 5%) w Low power and powerdown self refresh modes w Separate Row and Column buses for higher efficiency
XC18V04VQG44C 应用
Two power-saving features are embodied in the HY29DL16x. When addresses have been stable for a specified amount of time, the device enters the automatic sleep mode. The host can also place the device into the standby mode. Power con- sumption is greatly reduced in both these modes.
相关型号
型号
数量
厂商
批号
描述
询价
10241
11+
PARAMETER Reference Voltage Section Fb Voltage
13752
11+
The floating-point register file is made u
13848
Hardware Reset, active Low. Provides a hardware me
5208
A high on the MASTER RESET (MR) sets all the cont
14048
Addresses and chip enables are registered at risin
16717
The XC5200 Field-Programmable Gate Array Family i
15491
Wiper position programming defaults to midscale a
17695
The CS5381 uses a 5th-order, multi-bit delta-sigma
8886
The mounting area was reduced by mak- ing the tw
13759
The A-to-B enable (CEAB) input must be low in ord
17911
via an RF or an infrared transmission medium upo
4950
Note 2: The maximum power dissipation is dictated
4838
The BRT (Bias Resistor Transistor) contains
4726
The deserializer stays in lock until it cannot de
8877
Output, Pin 14, is suitable for controlling a pow
10249
Built-in Schmitt trigger circuit High level out
8879
This document states the current technical specif
15628
FEATURES lPhototransistor output lOpaque housing
11476
These features make the 4405x Series ideally suit