xc3s1600e-4fgg400i DataSheet
DATASHEET
xc3s1600e-4fgg400i 描述
Hardware Reset, active Low. Provides a hardware method of resetting the HY 29F400 to the read array state. When the device is reset, it immediately terminates any operation in progress. The data bus is tri-stated and all read/write commands are ignored while the input is asserted. While RESET# is asserted, the device will be in the Standby mode.
xc3s1600e-4fgg400i 特点
The XC3S1600E-4FGG400I is a Dual Non-Inverting Buffer with inde- pendent active HIGH enables for the 3-STATE outputs. The Ultra High Speed device is fabricated with advanced CMOS technology to achieve superior switching perfor- mance with high output drive while maintaining low static power dissipation over a broad VCC operating range. The device is specified to operate over the 1.65V to 5.5V VCC operating range. The inputs and outputs are high imped- ance when VCC is 0V. Inputs tolerate voltages up to 5.5V independent of VCC operating range. Outputs tolerate volt- ages above VCC when in the 3-STATE condition.
xc3s1600e-4fgg400i 应用
The SMJ320C67x DSPs are the floating-point DSP family in the SMJ320C6000 platform. The SMJ320C6701 (C6701) device is based on the high-performance, advanced VelociTI very-long-instruction-word (VLIW) architecture developed by Texas Instruments (TI), making this DSP an excellent choice for multichannel and multifunction applications. With performance of up to 1 giga floating-point operations per second (GFLOPS) at a clock rate of 167 MHz, the C6701 offers cost-effective solutions to high-performance DSP programming challenges. The C6701 DSP possesses the operational flexibility of high-speed controllers and the numerical capability of array processors. This processor has 32 general-purpose registers of 32-bit word length and eight highly independent functional units. The eight functional units provide four floating-/fixed-point ALUs, two fixed-point ALUs, and two floating-/fixed-point multipliers. The C6701 can produce two multiply-accumulates (MACs) per cycle for a total of 334 million MACs per second (MMACS). The C6701 DSP also has application-specific hardware logic, on-chip memory, and additional on-chip peripherals.
相关型号
型号
数量
厂商
批号
描述
询价
10241
11+
PARAMETER Reference Voltage Section Fb Voltage
13752
11+
The floating-point register file is made u
5208
A high on the MASTER RESET (MR) sets all the cont
14048
Addresses and chip enables are registered at risin
16717
The XC5200 Field-Programmable Gate Array Family i
17695
The CS5381 uses a 5th-order, multi-bit delta-sigma
8886
The mounting area was reduced by mak- ing the tw
13759
The A-to-B enable (CEAB) input must be low in ord
8877
Output, Pin 14, is suitable for controlling a pow
3499
The challenge for an integrated clock-recovery cir
3275
Continuous Drain Current, VGS @ 10V Continuous D
7426
Drive Up To 15 LSTTL Loads Low Power Consumption,
11466
High Power Switching Regulator Controller for DDR
10817
The internal circuit is composed of 2 stages inc
18287
The Edge646 driver supports three distinct program
19657
• True dual-ported memory cells which allow
3597
NOTES: 1. Stresses greater than those listed und
15724
Device on 50mm*50mm*1.5mm epoxy PCB FR4 wi
19154
Notes: 1. For Max. or Min. conditions, use appro
6530
International Rectifier radiation hardened HEXFET