VIPER12ADIP-E DataSheet
DATASHEET
VIPER12ADIP-E 描述
Notes: 1. Test conditions assume signal transition times of 5 ns or less, timing reference levels of 1.5V, input pulse levels of 0.4 to 2.2V and output loading specified in Figure 1. 2. Tested with the load in Figure 2. Transition is measured 500 mV from steady-state voltage. Not 100% tested.
VIPER12ADIP-E 特点
The VIPER12ADIP-E is designed to interface directly to the PCI or PCI-X bus and operate as a 64-bit DMA bus master. This function is accomplished through a PCI bus interface unit (PBIU) containing an on-board DMA controller. The PBIU generates and samples PCI control signals, generates host memory addresses, and facilitates the transfer of data between host memory and the on-board frame buffer. It also allows the host to access the VIPER12ADIP-E internal registers and communicate with the on-board RISC processor.
VIPER12ADIP-E 应用
Technical/Catalog InformationVIPER12ADIP-EVendorSTMicroelectronicsCategoryIntegrated Circuits (ICs) Packaging
相关型号
型号
数量
厂商
批号
描述
询价
10241
11+
PARAMETER Reference Voltage Section Fb Voltage
13752
11+
The floating-point register file is made u
13848
Hardware Reset, active Low. Provides a hardware me
5208
A high on the MASTER RESET (MR) sets all the cont
14048
Addresses and chip enables are registered at risin
16717
The XC5200 Field-Programmable Gate Array Family i
5239
The CM8560 is a low cost linear regulator designed
15491
Wiper position programming defaults to midscale a
17695
The CS5381 uses a 5th-order, multi-bit delta-sigma
8886
The mounting area was reduced by mak- ing the tw
13759
The A-to-B enable (CEAB) input must be low in ord
17911
via an RF or an infrared transmission medium upo
4950
Note 2: The maximum power dissipation is dictated
4838
The BRT (Bias Resistor Transistor) contains
4276
11+
CURRENT LIMIT PROTECTION The LX8819 includ
7426
11+
The AV34063 is a monolithic control circui